All-Power APG3010 Specifications download pdf (Page 21)

Owner’s Manual

Inspection, Cleaning, and

Maintenance

WARNING! ALWAYS MAKE SURE THE ENGINE POWER SWITCH IS IN ITS

“OFF” POSITION. DISCONNECT THE SPARK PLUG WIRE FROM THE ENGINE.

AND ALLOW SUFFICIENT TIME FOR THE ENGINE AND GENERATOR TO

COMPLETELY COOL BEFORE PERFORMING ANY INSPECTIONS,

MAINTENANCE, OR CLEANING.

• Before each use, inspect the generator. Check for:

- Loose screws

- Misaligned or binding moving parts

- Cracked or broken parts

- Damaged electrical wiring

- Any other condition that may affect safe operation.

• If an engine problem occurs, have it checked by a qualied service technical before further use.

Do not use damaged equipment.

• Before each use, make sure the engine’s oil and gas levels are adequate. If necessary, ll the

crankcase until the oil level is even with the oil hill hole and/or ll the fuel tank.

• Before each use, remove all debris with a soft

brush, rag, or vacuum.

• Lubricate all moving parts using a premium

quality, lightweight machine oil.

• Every 20 hours of use, drain the old engine oil

and replace with high quality SAE 10W-30

grade engine oil.

• Every 300 hours of use, have a qualied, certied

technician perform thorough maintenance on the

generator and engine.

• For long term storage, either drain fuel into

suitable container or add a fuel preservative/

stabilizer (not included) to prevent fuel

breakdown.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 34 35

No comments

All-Power APG3010 Specifications Page 21