All-Power APG3010 Specifications download pdf (Page 19)

Owner’s Manual

Operation (cont’d)

Powering 120 Volt AC Tools And Equipment:

1. Prior to powering tools and equipment, make sure the generator’s rated voltage, and amperage

capacity (120V/AC @ 13.75 AMPs) is adequate to supply all electrical loads that the unit will

power. If powering exceeds the generator’s capacity, it may be necessary to group one or more

of the tools and/or equipment for connection to a separate generator.

CAUTION: ATTEMPTING TO POWER SENSITIVE ELECTRONIC EQUIPMENT

WITHOUT THE USE OF AN APPROVED LINE CONDITIONER MAY CAUSE

DAMAGE TO THE EQUIPMENT. ALL POWER AMERICA IS NOT RESPONSIBLE

FOR ANY DIRECT OR INDIRECT DAMAGE CAUSED BY FAILURE TO USE AN

APPROVED LINE CONDITIONER.

2. Once the generator is running, simply connect the power cords of 110/120 volt AC powered

tools and equipment into the 120 volt AC dual outlets.

NOTE: THE GENERATOR FEATURES AN AC NON-FUSE CIRCUIT BREAKER

TO PROTECT THE AC CIRCUIT IN CASE OF AN OVERLOAD. SHOULD

AN OVERLOAD OCCUR, THE BREAKER WILL “TRIP” TO ITS “OFF” POSITION,

CAUSING THE GENERATOR TO AUTOMATICALLY SHUT DOWN. IN THIS CASE,

REFER TO STEP #1 ABOVE IN THIS POSITION. THEN, RESET THE CIRCUITRY

SYSTEM BY TURNING THE CIRCUIT BREAKER TO ITS “ON” POSITION.

RESTART THE GENERATOR AND CONTINUE POWERING THE REMAINING

TOOLS AND EQUIPMENT.

3. Note: The Generator features an AC Non-Fuse Circuit Breaker “OFF” position. Turn the fuel

valve to its “OFF” position.

4. Disconnect all electrical powered tools and equipment from the generator’s 110/120 volt AC

duel outlets.

5. After the engine and generator have completely cooled, store generator in a safe, clean, dry

location (if not already installed).

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 34 35

No comments

All-Power APG3010 Specifications Page 19