All-Power APG3001 Owner's Manual download pdf (Page 27)

Owner’s Manual

Inspection, Cleaning, and

Maintenance

Before each use, inspect the generator. Check for:

Loose screws

Misaligned or binding moving parts

Cracked or broken parts

Damaged electrical wiring

Any other condition that may affect safe operation.

If an engine problem occurs, have it checked by a qualified service

technical before further use. Do not use damaged equipment.

Before each use, make sure the engine’s oil and gas levels are

adequate. If necessary, fill the crankcase until the oil level is even with

the oil hill hole and/or fill the fuel tank.

Before each use, remove all debris with a soft brush, rag, or vacuum.

Lubricate all moving parts using a premium quality, lightweight machine

oil.

Every 20 hours of use, drain the old

engine oil and replace with

approximately ¾ (0.63) quart of a high

quality SAE 10W-30 grade engine oil.

Every 300 hours of use, have a

qualified, certified technician perform

thorough maintenance on the

generator and engine.

For long term storage, either drain fuel

into a suitable container or add a fuel

preservative/stabilizer (not included) to

prevent fuel breakdown.

WARNING! ALWAYS MAKE SURE THE ENGINE POWER SWITCH (2) IS

IN ITS “OFF” POSITION. DISCONNECT THE SPARK PLUG WIRE FROM

THE ENGINE. AND ALLOW SUFFICIENT TIME FOR THE ENGINE AND

GENERATOR TO COMPLETELY COOL BEFORE PERFORMING ANY

INSPECTIONS, MAINTENANCE, OR CLEANING.

1 2 ... 22 23 24 25 26 27 28 29 30

No comments

All-Power APG3001 Owner's Manual Page 27